HP Aruba JL253A Management And Configuration Manual page 690

a. At the prompt, enter the following commands:
Switch# configure
Switch(config)# vsf member 1 priority 200
Switch(config)# vsf member 1 link 1 24
All configuration on this port has been removed and port is placed in VSF mode.
Switch(config)# vsf member 1 link 2 23
All configuration on this port has been removed and port is placed in VSF mode.
To enable VSF, the REST interface will be disabled.
This will save the current configuration and reboot the switch.
Continue (y/n)? y
b. The above sequence of commands will configure the switch as member 1, with priority 200. Since this
switch has the highest priority configured, it becomes the Commander. The ports 23 and 24 are configured
on VSF links 2 and 1 respectively.
3. Log in to the second device, numbered
a. Physically connect member 2 with member 1 over the configured VSF ports, and execute the following
commands.
Switch# configure
Switch(config)# vsf member 2 priority 150
Switch(config)# vsf member 2 link 1 25
All configuration on this port has been removed and port is placed in VSF mode.
Switch(config)# vsf member 2 link 1 24
All configuration on this port has been removed and port is placed in VSF mode.
To enable VSF, the REST interface will be disabled.
This will save the current configuration and reboot the switch.
Continue (y/n)? y
b. The preceding sequence of commands will configure the member 2 with priority 150.
4. Log in to the third and fourth devices (configured as members
a. Physically connect member 3 with member 2. Enter the following commands on device 3:
Switch# configure
Switch(config)# vsf member 3 priority 100
Switch(config)# vsf member 3 link 1 26
All configuration on this port has been removed and port is placed in VSF mode.
Switch(config)# vsf member 3 link 2 25
All configuration on this port has been removed and port is placed in VSF mode.
To enable VSF, the REST interface will be disabled.
This will save the current configuration and reboot the switch.
Continue (y/n)? y
b. Physically connect member 4 with member 3. Enter the following commands on device 4:
Switch# configure
Switch(config)# vsf member 4 priority 100
Switch(config)# vsf member 4 link 1 27
All configuration on this port has been removed and port is placed in VSF mode.
Switch(config)# vsf member 4 link 2 26
All configuration on this port has been removed and port is placed in VSF mode.
To enable VSF, the REST interface will be disabled.
This will save the current configuration and reboot the switch.
Continue (y/n)? y
690
2
. It is configured as VSF member 2.
3
Aruba 2930F / 2930M Management and Configuration Guide
4
and respectively).
for ArubaOS-Switch 16.08