Configuring A Static Trunk Or Static Lacp Trunk Group; Removing Ports From A Static Trunk Group - HP Aruba JL253A Management And Configuration Manual

For arubaos-switch 16.08

Table of Contents

Configuring a static trunk or static LACP trunk group

IMPORTANT: Configure port trunking before you connect the trunked links between switches.

Otherwise, a broadcast storm could occur. (If you need to connect the ports before configuring them

for trunking, you can temporarily disable the ports until the trunk is configured. See "Enabling or

Disabling Ports and Configuring Port Mode".)

The "Port trunk features and operation" section describes the maximum number of trunk groups you can

configure on the switch. An individual trunk can have up to eight links, with additional standby links if you're using

LACP. You can configure trunk group types as follows:

The following examples show how to create different types of trunk groups.

trunk < port-list > < trk1 ... trk60 > {<trunk | lacp>}

Configures the specified static trunk type.

This Example: uses ports C4 to C6 to create a non-protocol static trunk group with the group name Trk2.

switch(config)# trunk c4-c6 trk2 trunk

CAUTION: Removing a port from a trunk can create a loop and cause a broadcast storm. When you

remove a port from a trunk where spanning tree is not in use, The switch recommends that you first

disable the port or disconnect the link on that port.

no trunk <port-list>

Removes the specified ports from an existing trunk group.

To remove ports C4 and C5 from an existing trunk group:

Chapter 5 Port Trunking

Trunk Group Membership

TrkX (Static)

DynX (Dynamic)