Table of Contents
Advertisement
5. You then see this prompt:
You have invoked the console download utility.
Do you wish to continue? (Y/N)>_
6. At the above prompt:
a. Enter y (for Yes)
b. Select Transfer|File in HyperTerminal.
c. Enter the appropriate filename and path for the OS image.
d. Select the Xmodem protocol (and not the 1k Xmodem protocol).
e. Click on [Send].
If you are using HyperTerminal, you will see a screen similar to the following to indicate that the download is in
progress:
Figure 96: Example: of Xmodem download in progress
When the download completes, the switch reboots from primary flash using the OS image you downloaded in
the preceding steps, plus the most recent startup-config file.
DNS resolver
The domain name system (DNS) resolver is designed for use in local network domains, where it enables the use
of a host name or fully qualified domain name with DNS-compatible switch CLI commands.
DNS operation supports both IPv4 and IPv6 DNS resolution and multiple, prioritized DNS servers. (For
information on IPv6 DNS resolution, see the latest IPv6 configuration guide for your switch.)
Basic operation
•
When the switch is configured with only the IP address of a DNS server available to the switch, a DNS-
compatible command, executed with a fully qualified domain name, can reach a device found in any domain
accessible through the configured DNS server.
•
When the switch is configured with both of the following:
544
Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08
Advertisement
Table of Contents
Troubleshooting
