Adding A Priority Description; Configuring The Severity Level For Event Log Messages Sent To A Syslog Server - HP Aruba JL253A Management And Configuration Manual

Syntax:
logging <ip-addr> [control-descr ZZZZTRISHZZZZ <text_string>]
no logging <ip-addr> [control-descr]
An optional user-friendly description that can be associated with a server IP address. If no description is entered,
this is blank. If <text_string> contains white space, use quotes around the string. IPv4 addresses only.
Use the no form of the command to remove the description. Limit: 255 characters
NOTE:
To remove the description using SNMP, set the description to an empty string.
The logging command with a control description
switch(config)# logging 10.10.10.2 control-descr syslog_one

Adding a priority description

This description can be added with the CLI or SNMP. The CLI command is:
Syntax:
logging priority-descr <text_string>
no logging priority-descr
Provides a user-friendly description for the combined filter values of severity and system module. If no
description is entered, this is blank.
If text_string contains white space, use quotes around the string.
Use the no form of the command to remove the description.
Limit: 255 characters
The logging command with a priority description
switch(config)# logging priority-descr severe-pri
NOTE:
A notification is sent to the SNMP agent if there are any changes to the syslog parameters, either
through the CLI or with SNMP.
Configuring the severity level for Event Log messages sent to a syslog
server
Event Log messages are entered with one of the following severity levels (from highest to lowest):
Major
Error
Warning
524
A fatal error condition has occurred on the switch.
An error condition has occurred on the switch.
A switch service has behaved unexpectedly.
Aruba 2930F / 2930M Management and Configuration Guide
Table Continued
for ArubaOS-Switch 16.08