HP Aruba JL253A Management And Configuration Manual page 134

Spanning Tree:
IP multicast protocol (IGMP):
VLANs:
Port security:
Monitor port:
134
802.1D (STP) and 802.1w (RSTP) Spanning Tree operate as a global setting
on the switch (with one instance of Spanning Tree per switch). 802.1s (MSTP)
Spanning Tree operates on a per-instance basis (with multiple instances
allowed per switch). For each Spanning Tree instance, you can adjust
Spanning Tree parameters on a per-port basis.A static trunk of any type
appears in the Spanning Tree configuration display, and you can configure
Spanning Tree parameters for a static trunk in the same way that you would
configure Spanning Tree parameters on a non-trunked port. (Note that the
switch lists the trunk by name—such as Trk1—and does not list the individual
ports in the trunk.) For example, if ports C1 and C2 are configured as a static
trunk named Trk1, they are listed in the Spanning Tree display as Trk1 and do
not appear as individual ports in the Spanning Tree displays. See A port trunk
in a Spanning Tree listing on page 135.When Spanning Tree forwards on a
trunk, all ports in the trunk will be forwarding. Conversely, when Spanning Tree
blocks a trunk, all ports in the trunk are blocked.
A dynamic LACP trunk operates only with the default Spanning Tree settings.
Also, this type of trunk appears in the CLI show spanning-tree display, but
not in the Spanning Tree Operation display of the Menu interface.
If you remove a port from a static trunk, the port retains the same Spanning
Tree settings that were configured for the trunk.In the below Example:, ports
C1 and C2 are members of TRK1 and do not appear as individual ports in the
port configuration part of the listing.See: A port trunk in a Spanning Tree
listing example
A static trunk of any type appears in the IGMP configuration display, and you
can configure IGMP for a static trunk in the same way that you would
configure IGMP on a non-trunked port. (Note that the switch lists the trunk by
name—such as Trk1—and does not list the individual ports in the trunk.) Also,
creating a new trunk automatically places the trunk in IGMP Auto status if
IGMP is enabled for the default VLAN.A dynamic LACP trunk operates only
with the default IGMP settings and does not appear in the IGMP configuration
display or show ip igmp listing.
Creating a new trunk automatically places the trunk in the DEFAULT_VLAN,
regardless of whether the ports in the trunk were in another VLAN. Similarly,
removing a port from a trunk group automatically places the port in the default
VLAN. You can configure a static trunk in the same way that you configure a
port for membership in any VLAN.
For a dynamic LACP trunk to operate in a VLAN other than the default VLAN
(DEFAULT_VLAN), GVRP must be enabled. See Trunk group operation
using LACP on page 142.
Trunk groups (and their individual ports) cannot be configured for port security,
and the switch excludes trunked ports from the show port-security
listing. If you configure non-default port security settings for a port, then
subsequently try to place the port in a trunk, you see the following message
and the command is not executed:< port-list> Command cannot operate
over a logical port.
A trunk cannot be a monitor port. A monitor port can monitor a static trunk but
cannot monitor a dynamic LACP trunk.
Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08