User Initiated Diagnostic Crash Via The Serial Console; Front-Panel-Security Diagnostic-Reset Serial-Console; [No] Front-Panel-Security Diagnostic-Reset Serial-Console - HP Aruba JL253A Management And Configuration Manual

Event
Console print
Console print

User initiated diagnostic crash via the serial console

Remotely triggers a diagnostic reset of the switch via a serial console. This reset reboots the switch and collects
diagnostic data for debugging an application hang, a system hang or any other rare occurrence. Diagnostic reset
is controlled via FPS options.
The serial sequence to initiate the User Initiated Diagnostic Reset via Serial console is Ctrl+S, Ctrl+T, Ctrl+Q, Ctrl
+T, Ctrl+S.

Front-panel-security diagnostic-reset serial-console

In the configure context:
Syntax
front-panel-security diagnostic-reset serial-console
Enables the diagnostic-reset via serial console. Allows the user to perform diagnostic reset by keying-in
diagnostic reset sequence.
Front-panel-security diagnostic-reset serial-console
front-panel-security diagnostic-reset serial-console
Diagnostic Reset
clear-button
serial-console

[No] front-panel-security diagnostic-reset serial-console

In the configure context:
Syntax
[no] front-panel-security diagnostic-reset serial-console
584
Message
STKM: HA Sync in progress; user initiated
diagnostic request via the serial console
rejected. Retry after sometime.
Printed on the device console. When standby
is in sync state, we don't want to crash the
commander. So we report to the user to retry
later
STKM: Member is booting; user initiated
diagnostic request via the serial console
rejected. Retry after sometime.
Printed on the device console. When the
member is till booting, it doesn't have the
commander member number, thus we can't
issue UIDC on the commander. So we report
to the user to retry later.
- Enabled
- Disabled
- Enabled
Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08