Table of Contents
Advertisement
To configure syslog operation in these ways with the debug/syslog feature disabled on the switch, enter the
commands shown in Figure 88: Debug/syslog configuration for multiple debug types and multiple
destinations on page 517.
Figure 88: Debug/syslog configuration for multiple debug types and multiple destinations
Debug command
At the manager level, use the debug command to perform two main functions:
•
Specify the types of event messages to be sent to an external destination.
•
Specify the destinations to which selected message types are sent.
By default, no debug destination is enabled and only Event Log messages are enabled to be sent.
NOTE:
To configure a syslog server, use the logging <syslog-ip-addr> command. For more
information, see Configuring a syslog server on page 521.
Debug messages
Syntax:
[no] debug <debug-type>
Chapter 13 Troubleshooting
517
Advertisement
Table of Contents
Troubleshooting
