Xmodem: Copying A Configuration File From A Serially Connected Pc Or Unix Workstation (Cli) - HP Aruba JL253A Management And Configuration Manual

switch# copy startup-config xmodem pc
Press 'Enter' and start XMODEM on your host...
3. After you see the above prompt, press [Enter].
4. Execute the terminal emulator commands to begin the file transfer.
Xmodem: Copying a configuration file from a serially connected PC or
UNIX workstation (CLI)
To use this method, the switch must be connected via the serial port to a PC or UNIX workstation on which is
stored the configuration file you want to copy. To complete the copying, you need to know the name of the file to
copy and the drive and directory location of the file.
Syntax:
copy xmodem startup-config {<pc | unix>}
copy xmodem config <filename> < {pc | unix>}
Copies a configuration file from a serially connected PC or UNIX workstation to a designated configuration file on
the switch.
For more information, see "Multiple Configuration Files" in the basic operation guide for your switch.
Example:
To copy a configuration file from a PC serially connected to the switch:
Procedure
1. Execute the following command:
switch# copy xmodem startup-config pc
Device will be rebooted, do you want to continue [y/n]? y
Press 'Enter' and start XMODEM on your host...
2. After you see the above prompt, press [Enter].
3. Execute the terminal emulator commands to begin the file transfer.
4. When the download finishes, you must reboot the switch to implement the newly downloaded software. To do
so, use one of the following commands:
Syntax:
boot system flash [primary | secondary]
boot system flash [config < filename >]
Switches boot from the designated configuration file. For more information, see "Multiple Configuration Files"
in the basic operation guide for your switch.
Syntax:
reload
Reboots from the flash image currently in use.
Chapter 11 File Transfers 361