Viewing Static Lacp And Dynamic Lacp Trunk Data; Dynamic Lacp Standby Links - HP Aruba JL253A Management And Configuration Manual

For arubaos-switch 16.08

Table of Contents

specifying ports on page 136, the command does not include a port list, so the switch lists all ports having static

trunk membership.

A show trunk listing without specifying ports

switch# show trunks

Load Balancing

---- + ----------------------- --------- + ----- -----

| Print-Server-Trunk

Viewing static LACP and dynamic LACP trunk data

Lists data for only the LACP-configured ports.

Ports A1 and A2 have been previously configured for a static LACP trunk. (For more on the Active parameter,

see table "LACP port status data".)

A show LACP listing

switch# show lacp

For a description of each of the above-listed data types, see table "LACP port status data".

Dynamic LACP trunking enables you to configure standby links for a trunk by including more than eight ports in a

dynamic LACP trunk configuration. When eight ports (trunk links) are up, the remaining link(s) will be held in

standby status. If a trunked link that is "Up" fails, it will be replaced by a standby link, which maintains your

intended bandwidth for the trunk. (Refer to also the "Standby" entry under "Port Status" in "Table 4-5. LACP Port

Status Data".) In the next Example:, ports A1 through A9 have been configured for the same LACP trunk. Notice

that one of the links shows Standby status, while the remaining eight links are "Up".

A Dynamic LACP trunk with one standby link

switch# show lacp

| Group Type

Aruba 2930F / 2930M Management and Configuration Guide

------ ------

for ArubaOS-Switch 16.08