Table of Contents
Advertisement
(UDP port 9512 is used.)
Syntax:
[no] logging facility <facility-name>
The logging facility specifies the destination subsystem used in a configured syslog server. (All configured syslog
servers must use the same subsystem.) Hewlett Packard Enterprise recommends the default (user) subsystem
unless your application specifically requires another subsystem. Options include:
user
kern
mail
daemon
auth
syslog
lpr
news
uucp
cron
sys9
sys10 - sys14
local10 - local17
Use the no form of the command to remove the configured facility and reconfigure the default (user) value.
Adding a description for a Syslog server
You can associate a user-friendly description with each of the IP addresses (IPv4 only) configured for syslog
using the CLI or SNMP.
NOTE:
The Hewlett Packard Enterprise MIB hpicfSyslog.mib allows the configuration and monitoring of
syslog for SNMP (RFC 3164 supported).
CAUTION:
Entering the no logging command removes ALL the syslog server addresses without a verification
prompt.
The CLI command is:
Chapter 13 Troubleshooting
(default) Random user-level messages
Kernel messages
Mail system
System daemons
Security/authorization messages
Messages generated internally by syslog
Line-printer subsystem
Netnews subsystem
uucp subsystem
cron/at subsystem
cron/at subsystem
Reserved for system use
Reserved for system use
523
Advertisement
Table of Contents
Troubleshooting
