Table of Contents
Advertisement
Received disconnect from 10.0.12.31: 2: Wait for previous
session to complete
lost connection
Attempt to start a second session
The switch supports only one SFTP session or one SCP session at a time. If a second session is initiated (For
example, an SFTP session is running and then an SCP session is attempted), the following error message may
appear on the client console:
Received disconnect from 10.0.12.31: 2: Other SCP/SFTP
session running
lost connection
Using Xmodem to download switch software from a PC or UNIX
workstation
This procedure assumes that:
•
The switch is connected via the Console RS-232 port to a PC operating as a terminal. (For information on
connecting a PC as a terminal and running the switch console interface, see the installation and getting started
guide you received with the switch.)
•
The switch software is stored on a disk drive in the PC.
•
The terminal emulator you are using includes the Xmodem binary transfer feature. (For example, in the
HyperTerminal application included with Windows NT, you would use the Send File option in the Transfer
drop-down menu.)
Downloading to primary or secondary flash using Xmodem and a terminal emulator
(CLI)
Syntax:
copy xmodem flash [<primary | secondary>]
Downloads a software file to primary or secondary flash. If you do not specify the flash destination, the Xmodem
download defaults to primary flash.
Example:
To download a switch software file named E0822.swi from a PC (running a terminal emulator program such as
HyperTerminal) to primary flash:
Procedure
1. Execute the following command in the CLI:
switch# copy xmodem flash
Press 'Enter and start XMODEM on your host...
2. Execute the terminal emulator commands to begin the Xmodem transfer. For example, using HyperTerminal:
a. Click on Transfer, then Send File.
b. Type the file path and name in the Filename field.
354
Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08
Advertisement
Table of Contents
Troubleshooting
