HP Aruba JL253A Management And Configuration Manual page 512

For arubaos-switch 16.08
Table of Contents

Advertisement

ip
fib: Displays IP Forwarding
Information Base messages and
events.forwarding: Sends IPv4
forwarding messages to the debug
destinations.ospf: Sends OSPF
event logging to the debug
destinations.ospfv3: Enables
debug messages for
OSPFv3.packet: Sends IPv4
packet messages to the debug
destinations. pim [packet
[filter {source < ip-addr
> | vlan < vid >}]] : Enables
or disables tracing of PIM
messages.Note: When PIM
debugging is enabled, the following
message displays:
PIM Debugging can be
extremely CPU intensive
when run
on a device with an
existing high CPU load or
on a switch
with more than 10 PIM-
enabled VLANs. In high
load
situations, the switch
may suffer from protocol
starvation, high latency,
or even reload. When
debugging
a switch with more than
10 PIM-enabled VLANs, the
"vlan"
option in "debug ip pim
packet" should be
utilized.
Debugging should only be
used temporarily while
troubleshooting problems.
Customers are advised to
exercise caution when
running this command in a
highstress
production network.
pbr: Logs a message when a PBR
policy is applied, when the action in
a class goes active or when it goes
inactive.rip: Sends RIP event
logging to the debug destinations.
Table Continued
512
Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08

Advertisement

Table of Contents
loading

Table of Contents