HP Aruba JL253A Management And Configuration Manual page 529

timeout <1-60>
source {< ip-addr | vid |
loopback <0-7>>}
data-size <0-65471>
data-fill <0-1024>
ip-option
tos <0-255>
Ping tests
switch# ping 10.10.10.10
10.10.10.10 is alive, time = 15 ms
switch# ping 10.10.10.10 repetitions 3
10.10.10.10 is alive, iteration 1, time = 15 ms
10.10.10.10 is alive, iteration 1, time = 15 ms
10.10.10.10 is alive, iteration 1, time = 15 ms
switch# ping 10.10.10.10 timeout 2
10.10.10.10 is alive, time = 10 ms
Chapter 13 Troubleshooting
Timeout interval in seconds; the ECHO REPLY must be received before
this time interval expires for the ping to be successful.
Default: 5
Source IP address, VLAN ID, or loopback address used for the ping.
The source IP address must be owned by the router.If a VLAN is specified,
the IP address associated with the specified VLAN is used.
Size of packet sent.
Default: 0 (zero)
The data pattern in the packet.
Default: Zero length string
Specify an IP option, such as loose or strict source routing, or an include-
timestamp option:include-timestamp: Adds the timestamp option to the
IP header. The timestamp displays the amount of travel time to and from a
host.
Default: 9include-timestamp-and-address: Records the
intermediate router's timestamp and IP address.
Default: 4include-timestamp-from: Records the timestamp of the
specified router addresses.loose-source-route <IP-addr> : The
loose-source-route option prompts for the IP address of each source
IP on the path. It allows you to specify the IP addresses that you want the
ping packet to go through; the packet may go through other IP addresses
as well.record-route <1-9> : Displays the IP addresses of the
interfaces that the ping packet goes through on its way to the destination
and on the way back.
When specified without loose or strict recording, the source route is not
recorded. The source route is automatically recorded when loose or strict
source routing is enabled.
Default: 9strict-source-route <IP-addr> : Restricts the ping
packet to only those IP addresses that have been specified and no other
addresses.
Specifies the type of service to be entered in the header packet.
Default: 0 (zero)
529