Default Ap Profile; Allow-Jumbo-Frames; Auto Configuring Iot Devices; Creating A Device Identity And Associating A Device Type - HP Aruba JL253A Management And Configuration Manual

Default AP Profile

Creates a user-defined profile.
The profile name is a valid character string with the maximum permissible length of 32. The default profile is
named default-ap-profile and cannot be modified.
The default configuration parameters may be modified using the command device-<PROFILE NAME>
default-ap-profile . Up to four different profiles may be configured.
The [no] command removes the user-defined profiles.

allow-jumbo-frames

Syntax
allow-jumbo-frames
Description
Configure jumbo frame support for the device port. Jumbo frames are not enabled by default.
Validation rules
Validation
Invalid jumbo command.
If jumbo frame support is configured on a VLAN for
which the device profile had overridden the
configuration, display the existing warning.

Auto configuring IoT Devices

Wired IoT devices can also be automatically configured using device profiles. Since the market for IoT devices is
vast, with several hundred manufacturers and thousands of devices, instead of hardcoding the LLDP signatures,
Aruba switches provide a way for an administrator to create a device type for the IoT devices in their deployment.
By associating the custom device type that they create with a device profile, users can leverage the power profiles
not only for Aruba devices but also for other manufacturers. The requirement for automatic detection of IoT
devices is that they should support LLDP.

Creating a device identity and associating a device type

Procedure
1. Create a device identity using the command:
switch# device-identity name <DEVICE-NAME>
2. Specify the OUI used in LLDP's organization using specific TLV, (type =127). OUI should be in XXXXXX
format. The default OUI "000000" indicates that device-identity will not use LLDP to identify device:
switch(config)# device-identity name <DEVICE-NAME> lldp oui <MAC_OUI>
sub-type <SUBTYPE>
To add new device on switch:
switch(config)# device-identity name abc lldp oui a1b2c3 sub 2
720
Error/Warning/Prompt
Invalid input.
This configuration change will be delayed because a
device profile that enables jumbo frame support is
applied to a port in this VLAN.
Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08