Table of Contents
Advertisement
NOTE: The following procedure requires the use of Xmodem and copies an OS image into primary
flash only.
This procedure assumes you are using HyperTerminal as your terminal emulator. If you use a
different terminal emulator, you may need to adapt this procedure to the operation of your particular
emulator.
1. Start the terminal emulator program.
Ensure that the terminal program is configured as follows:
•
Baud rate: 9600
•
No parity
•
8 Bits
•
1 stop bit
•
No flow control
2. Use the Reset button to reset the switch.
The following prompt should then appear in the terminal emulator:
Enter h or ? for help.
=>
3. Because the OS file is large, you can increase the speed of the download by changing the switch console and
terminal emulator baud rates to a high speed. For Example:
a. Change the switch baud rate to 115,200 Bps.
=> sp 115200
b. Change the terminal emulator baud rate to match the switch speed:
I.
In HyperTerminal, select Call|Disconnect.
II.
Select File|Properties.
III.
Click on Configure.
IV.
Change the baud rate to 115200.
V.
Click on [OK], then in the next window, click on [OK] again.
VI.
Select Call|Connect.
VII.
Press [Enter] one or more times to display the => prompt.
4. Start the Console Download utility by entering do at the =prompt and pressing [Enter]:
=> do
Chapter 13 Troubleshooting
543
Advertisement
Table of Contents
Troubleshooting
