Snmp-Server Enable Traps Dyn-Ipv6-Lockdown - HP Aruba JL253A Management And Configuration Manual

Validation
If DSNOOPV6 is globally disabled when
configuring a static binding.
While configuring a static binding if the Ipv6
address is already present in the Binding table but
the entered vlanid and MAC address doesnot
match with the one present in the binding table.
If a binding which does not exist in the binding
table is tried to be removed.
If DIPLDv6 limits are exceeded on the switch.
If more than 4 IPv6 addresses are being assigned
to a VID/MAC pair
If a VID-MAC pair is bound to a link-local address
and the same VID-MAC pair is being assigned
another link-local address.
If a binding exists for a particular client in the BST
and the same binding is being configured for
another port.
If the switch total limit for bindings is exceeded.
If a trunk is being configured for a port which has
static binding configured on it.
If static binding is being configured on a Smart Link
enabled port
If Smart Link is being configured on a port with
static binding.

snmp-server enable traps dyn-ipv6-lockdown

Syntax
[no] snmp-server enable traps dyn-ipv6-lockdown [out-of-resources | violations]
Description
The Dynamic IPv6 Lockdown trap is sent when resources are unavailable for configuring. This trap is sent when a
source lockdown violation takes place.
Parameters and options
Chapter 9 DHCPv6 server
Error/Warning/Prompt
Cannot configure static binding whenDHCPv6
Snooping is disabled.
%s has already been assigned to a VID/MAC.
Delete the existing binding first.
Binding for %s not found.
Cannot add the IPv6 source binding because the
number of source bindings exceeds the maximum
limit of
"STR(DSNOOPV6_MAX_STATIC_LEASES)".
Cannot add the IPv6 source binding because only
"STR(DHCPV6_MAX_IAADDRS)"IPv6 addresses
can be bound to a VID-MAC pair.
%s is already bound to a link-local address. To
bind another link-local address, delete the existing
binding .
The IPv6 source binding already exists for another
port.
Cannot add the IPv6 source binding because the
number of source bindings exceeds the maximum
limit of
STR(DSNOOPV6_MAX_STATIC_LEASES).
Cannot add a port to a trunk group when IPv6
source binding is configured on that port.
Cannot configure IPv6 source binding on a Smart
Link port.
Cannot configure Smart Link feature on a port
when IPv6 source binding is configured on that
port.
281