[No] Ip-Sla <Id> Schedule; [No] Ip-Sla <Id> Tos; [No] Ip-Sla Responder; [No] Ip-Sla <Id> Udp-Jitter - HP Aruba JL253A Management And Configuration Manual

Description
Configure action to be taken when test gets completed.
• trap: Send snmp-trap when configured threshold is hit.
• log: Only log the event when configured threshold is hit.
• trap-log: Send snmp-trap and log the event when configured threshold is hit.
• none: Take no action.
[no] ip-sla <ID> schedule
Syntax
[no] ip-sla <ID> schedule [[now | startTime <START-TIME>] [forever | stopTime <STOP-TIME>
| repetitions <NUM>] [frequency <FREQUENCY>
Description
Configure the start time, stop time, lifetime, and frequency of run for the IP SLA. The default value for the
frequency of operation is 60 seconds.
[no] ip-sla <ID> tos
Syntax
[no] ip-sla <ID> tos <VALUE>
Description
Configure the Type of Service value to be set in the test packet for the IP SLA.
Valid values: 0–255

[no] ip-sla responder

Syntax
[no] ip-sla responder
Description
Configure SLA responder to respond to probe packets.
• IP address: local interface IP address
• port: takes L4 port numbers.
• SLA types supported: udp-echo, tcp-connect, UDP Jitter & Jitter For VoIP.
[no] ip-sla <ID> udp-jitter
Syntax
[no] ip-sla <ID> udp-jitter destination [<IP-ADDR> | <HOST-NAME>] <PORT-NUM>
source [<IP-ADDR> | <VLAN-ID>] [payload-size <SIZE> num-of-packets <NUM> packet-
interval <PKT-INTERVAL>]
Description
Configures the UDP Jitter test.
592 Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08