Configuring An Oobm Ipv4 Address; Configuring An Oobm Ipv4 Default Gateway - HP Aruba JL253A Management And Configuration Manual

Syntax
oobm interface speed-duplex [10-half | 10-full | 100-half | 100-full | auto]
Enables or disables the networked OOBM interface (port.) Available settings are:
10-half
10-full
100-half
100-full
auto
Example
Switch (oobm)# interface speed-duplex auto

Configuring an OOBM IPv4 address

Configuring an IPv4 address for the OOBM interface is similar to VLAN IP address configuration, but it is
accomplished within the OOBM context.
From the OOBM context:
Syntax
[no] ip address [dhcp-bootp | ip-address/mask-length]
From the general configuration context:
Syntax
[no] oobm ip address [dhcp-bootp | ip-address/mask-length]
Configures an IPv4 address for the switch's OOBM interface.
You can configure an IPv4 address even when global OOBM is disabled; that address will become effective when
OOBM is enabled.
Example
Switch (oobm)# ip address 10.1.1.17/24

Configuring an OOBM IPv4 default gateway

Configuring an IPv4 default gateway for the OOBM interface is similar to VLAN default gateway configuration, but
it is accomplished within the OOBM context.
From the OOBM context:
Syntax
[no] ip default-gateway ip-address
From the general configuration context:
736
10 Mbps, half-duplex
10-Mbps, full-duplex
100-Mbps, half-duplex
100-Mbps, full-duplex
auto negotiate for speed and duplex
Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08