Operating Notes - HP Aruba JL253A Management And Configuration Manual

Inbound multicast rate-limiting of 20% on port 3
switch(eth-3)# rate-limit mcast in percent 20
switch(eth-3)# show rate-limit mcast
Multicast-Traffic Rate Limit Maximum %
Port | Inbound Limit Mode
----- + ------------- --------- ---------------
1 | Disabled
2 | Disabled
3 | 20
4 | Disabled
To disable rate-limiting for a port enter the no form of the command, as shown in Disabling inbound multicast
rate-limiting for port 3 on page 164.
Disabling inbound multicast rate-limiting for port 3
switch(eth-3)# no rate-limit mcast in
switch(eth-3)# show rate-limit mcast
Multicast-Traffic Rate Limit Maximum %
Port | Inbound Limit Mode
----- + ------------- --------- ---------------
1 | Disabled
2 | Disabled
3 | Disabled
4 | Disabled

Operating Notes

The following information is displayed for each installed transceiver:
• Port number on which transceiver is installed.
• Type of transceiver.
• Product number — Includes revision letter, such as A, B, or C. If no revision letter follows a product number,
this means that no revision is available for the transceiver.
• Part number — Allows you to determine the manufacturer for a specified transceiver and revision number.
• For a non-Aruba switches installed transceiver, no transceiver type, product number, or part information is
displayed. In the Serial Number field, non-operational is displayed instead of a serial number.
• The following error messages may be displayed for a non-operational transceiver:
◦
Unsupported Transceiver. (SelfTest Err#060)
◦
This switch only supports revision B and above transceivers.
◦
Self test failure.
◦
Transceiver type not supported in this port.
164
Radius Override
Disabled No-override
Disabled No-override
% No-override
Disabled No-override
Radius Override
Disabled No-override
Disabled No-override
Disabled No-override
Disabled No-override
Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08