Error Messages Associated With The Show Interfaces Command - HP Aruba JL253A Management And Configuration Manual

For arubaos-switch 16.08

Table of Contents

Parameter column

The custom show interfaces command

switch(config)# show int custom 1-4 port name:4 type vlan intrusion speed enabled mdi

Status and Counters - Custom Port Status

---- ---------- ---------- ----- --------- ------- ------- --------

You can specify the column width by entering a colon after the column name, then indicating the number of

characters to display. In the above example, the Name column displays only the first four characters of the name.

All remaining characters are truncated.

NOTE: Each field has a fixed minimum width to be displayed. If you specify a field width smaller than

the minimum width, the information is displayed at the minimum width. For example, if the minimum

width for the Name field is 4 characters and you specify Name:2, the Name field displays 4

You can enter parameters in any order. There is a limit of 80 characters per line; if you exceed this limit an error

Error messages associated with the show interfaces command

The following table provides information on error messages associated with the show interfaces custom

Requesting too many fields (total characters exceeds

Field name is misspelled

Mistake in specifying the port list

The port list is not specified

Friendly port name

The vlan id this port belongs to, or "tagged" if it

belongs to more than one vlan

port is or is not enabled

Intrusion alert status

Broadcast limit

Enabled MDI-mode

Error message

Total length of selected data exceeds one line

Invalid input: <input>

Module not present for port or invalid port: <input>

Incomplete input: custom

Aruba 2930F / 2930M Management and Configuration Guide

yes or nointrusion

for ArubaOS-Switch 16.08