Ipv6 Source-Binding - HP Aruba JL253A Management And Configuration Manual

ipv6 source-binding

Syntax
[no] ipv6 source-binding VLAN-ID IPV6-ADDR MAC-ADDR PORT-NUM IPV6-ADDR
Description
Add a DHCPv6 static binding entry into the binding table. Static binding entries will have infinite lifetime.
Parameters and options
VLAN-ID
The VLAN ID of the static binding entry.
Ipv6-ADDRESS
The Ipv6 address of the static binding entry.
MAC-ADDRESS
The MAC address of the static binding entry.
[ethernet] PORT-NUM
Port number of the static binding entry.
IPV6-ADDR
The Ipv6 link-local address of the static binding entry.
Validation rules
Validation
Verify whether the vlan id is proper
Verify whether the mac-address is valid
Verify whether the ipv6 address is valid
Verify whether the port number is valid on the
device
If any other addresses other than global unicast
address are entered
If the ipv6 address entered is not a unicast.
If a multicast ipv6 address is entered to configure a
binding.
If an invalid MAC address is being added into the
binding table.
If an invalid port is used for configuring a static
binding
280
Error/Warning/Prompt
Invalid input:%s
Invalid input:%s
Invalid input:%s
Module not present for port or invalid port: <port-
num>
Invalid Ipv6 address
Only Ipv6 unicast addresses are supported.
Cannot configure a binding using a multicast IPV6
address.
Cannot add a %s MAC address to the table.
Port %s is invalid.
Aruba 2930F / 2930M Management and Configuration Guide
Table Continued
for ArubaOS-Switch 16.08