Table of Contents
Advertisement
Description
Configure the Aruba VPN type, peer IP address. When Aruba VPN type is any, the tunnel is established
independent of Airwave configuration.
The no form of the command removes the aruba-vpn type statement from the configuration.
Parameters
type
Configure the controller IP.
amp
Configure Remote Access VPN session to protect specific switch generated traffic. It also supports secure
ZTP of Airwave Management Platform (AMP) server.
any
Configure Remote Access VPN session to protect specific switch generated traffic. Secure ZTP is not
supported.
<IP_addr>
IP address of the VPN.
Usage
switch(config)# aruba-vpn type
switch(config)# aruba-vpn type amp
switch(config)# aruba-vpn type amp peer-ip
switch(config)# aruba-vpn type any
NOTE:
•
•
Show commands
show aruba-vpn
Syntax
show aruba-vpn type <VPN-TYPE>
Description
Show Aruba-VPN configuration information.
show aruba-vpn
show aruba-vpn
320
When you configure aruba-vpn type as any, the switch creates a tunnel and updates the
inner-ip.
You can create routes using the ip route command for next hop as aruba-vpn sends
management traffic over the tunnel. For example: ip route 2.0.0.0 255.255.255.0
tunnel aruba-vpn
Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08
Advertisement
Table of Contents
Troubleshooting
