HP Aruba JL253A Management And Configuration Manual page 39

version
The protocol version of the SNTP server. Allowable values are 1 through 7; default is 3.
Syntax:
no sntp server priority <1-3> <ip-addr>
Deletes the specified SNTP server.
NOTE:
priority <1-3>
value must match what server is configured with. Deleting an SNTP server when only one is
configured disables SNTP unicast operation.
Example:
To select SNTP and configure it with unicast mode and an SNTP server at 10.28.227.141 with the default server
version (3) and default poll interval (720 seconds):
switch(config)# timesync sntp
Selects SNTP.
switch(config)# sntp unicast
Activates SNTP in unicast mode.
switch(config)# sntp server priority 1 10.28.227.141
Specifies the SNTP server and accepts the current SNTP server version (default: 3).
Configuring SNTP for unicast operation
switch(config)# show sntp
SNTP Configuration
Time Sync Mode: Sntp
SNTP Mode : Unicast
Poll Interval (sec) [720] : 720
Priority SNTP Server Address
-------- ---------------------------------------------- ----------------
1 2001:db8::215:60ff:fe79:8980 7
2 10.255.5.24 3
3 fe80::123%vlan10 3
In this Example:, the Poll Interval and the Protocol Version appear at their default settings.
Both IPv4 and IPv6 addresses are displayed.
Note: Protocol Version appears only when there is an IP address configured for an SNTP server.
If the SNTP server you specify uses SNTP v4 or later, use the sntp server command to specify the correct
version number. For example, suppose you learned that SNTP v4 was in use on the server you specified above
(IP address 10.28.227.141). You would use the following commands to delete the server IP address , re-enter it
with the correct version number for that server.
Chapter 2 Time Protocols
Protocol Version
39