Image Upgrade; Troubleshooting; Amp Server Messages; Activate Based Ztp With Airwave - HP Aruba JL253A Management And Configuration Manual

For arubaos-switch 16.08

Table of Contents

Image Upgrade

If you upgrade from any 15.xx version to version 16.xx, the following minimal set of configuration is validated to

enable or disable the ZTP process:

If the switch has any other VLAN apart from the default VLAN, ZTP gets disabled.

In default VLAN, if the IPv4 address is not set as DHCP (default option is DHCP), ZTP gets disabled.

In default VLAN, if IPv6 is enabled or configured, ZTP gets disabled.

If you have any other configuration during the upgrade, ZTP will continue to be in the enabled state.

You can troubleshoot switches by using the SSH connection and the device logs available in AirWave. For a list of

all RMON message, refer to ArubaOS-Switch Event Log Message Reference Guide.

You can enable the debug logging with the debug ztp command, see debug ztp.

To display the AMP server debug messages, enter:

switch# debug ztp

To print the debug messages to the terminal, enter:

switch# debug destination session

ZTP with Activate is used in the following scenarios to help switches check in through the Internet with public

facing instances of Airwave:

Deployments where administrators do not have a DHCP server to configure Airwave options

Absence of corporate network reaching every branch

For Activate-based ZTP, the switch connects to Aruba Activate service through the Internet and autoconfiguration

takes place based on the settings provided in Activate. For more information on how to set up an Activate

account, folder and their rules, refer to the Aruba Activate User Guide.

Chapter 10 Zero Touch Provisioning with AirWave and Central

Activate based ZTP is not supported for IPv6.

Activate based ZTP is not supported for both IPv4 and IPv6 through OOBM.