Viewing And Configuring Port Trunk Groups (Cli); Viewing Static Trunk Type And Group For All Ports Or For Selected Ports - HP Aruba JL253A Management And Configuration Manual

For arubaos-switch 16.08

Table of Contents

Recommended port mode setting for LACP

switch(config)# show interfaces config

Port Settings

----- --------- + ------- ------------ --------- ----

A port trunk in a Spanning Tree listing

----- --------- ---- -------- ---------- + -----------------

Viewing and configuring port trunk groups (CLI)

You can list the trunk type and group for all ports on the switch or for selected ports. You can also list LACP-only

status information for LACP-configured ports.

show trunks [< port-list >]

Omitting the <port-list> parameter results in a static trunk data listing for all LAN ports in the switch.

In a switch where ports A4 and A5 belong to Trunk 1 and ports A7 and A8 belong to Trunk 2, you have the

options shown in Listing specific ports belonging to static trunks on page 135 and A show trunk listing

without specifying ports on page 136 for displaying port data for ports belonging to static trunks.

Using a port list specifies, for switch ports in a static trunk group, only the ports you want to view. In this case, the

command specifies ports A5 through A7. However, because port A6 is not in a static trunk group, it does not

appear in the resulting listing:

Listing specific ports belonging to static trunks

switch# show trunks e 5-7

Load Balancing

---- + ----------------------- --------- + ----- -----

| Print-Server-Trunk

The show trunks <port-list> command in the above Example: includes a port list, and thus shows trunk

group information only for specific ports that have membership in a static trunk. In A show trunk listing without

Chapter 5 Port Trunking

| Enabled Mode

Cost Priority State

Forwarding | 0020c1-b27ac0

Forwarding | 0060b0-889e00

Forwarding | 0001e7-a0ec00

Flow Ctrl MDI

| Designated Bridge

| Group Type