Cfg-Restore Non-Blocking - HP Aruba JL253A Management And Configuration Manual

In the preceding output, Command : console terminal none shows that cfg-restore failed because a
reboot is required.
After the switch reboots and comes up, the golden_config becomes the active configuration.
NOTE: In case of a switch reboot, the switch comes up with the configuration associated with the
primary or secondary.
id | act pri sec | name
---+-------------+------------------------------------------------
1 | *
2 |
3 | *
4 |
5 |
switch# show cfg-restore status
Status
Config File Name
Source
Time Taken
Last Run
Recovery Mode
Failure Reason
Number of Add Commands
Number of Remove Commands : 5
Time Taken for Each Phase :
Calculating diff
Adding commands
Removing commands
NOTE: Time taken for adding and deleting commands is zero, as the switch reboots. It is similar to
downloading a startup-configuration to the device.

cfg-restore non-blocking

Syntax
cfg-restore {flash | tftp | sftp} <FILE-NAME> non-blocking
Description
Performs restore in non-blocking mode.
Command context
config
Example
switch(config)# cfg-restore flash add non-blocking
Current running-configuration will be replaced with 'add'.
Continue (y/n)? y
Configuration restore is in progress, configuration changes are
temporarily disabled.
switch(config)#
Chapter 15 Configuration backup and restore without reboot
* | config
| def
| golden_config
|
|
: Success
: default
: Flash
: 1 Seconds
: Mon Oct 23 07:17:03 2017
: Enabled
: -
: 0
: 1 Seconds
: 0 Seconds
: 0 Seconds
563