Show Interface Smartrate; Viewing Port Utilization Statistics (Cli) - HP Aruba JL253A Management And Configuration Manual

For arubaos-switch 16.08

Table of Contents

Note on using pattern matching with the show interfaces custom command

If you have included a pattern matching command to search for a field in the output of the show int custom

command, and the show int custom command produces an error, the error message may not be visible and

the output is empty. For example, if you enter a command that produces an error (such as vlan is misspelled) with

the pattern matching include option, the output may be empty:

Switch(config)# show int custom 1-3 name vlun

It is advisable to try the show int custom command first to ensure there is output, and then enter the

command again with the pattern matching option.

Note that in the above command, you can substitute int for interface; that is: show int custom.

show interface smartrate

show interface <PORT-LIST> smartrate

The option smartrate has been added to the show interface <PORT-LIST> command. This option is used

to display port diagnostics on a Smart Rate port only. If the command is run on a non‐Smart Rate port, a

message similar to Port A1: This command is only applicable to Smart Rate ports is

The show interface <PORT-LIST> smartrate command can be used to retrieve the physical layer link

diagnostics information for the smartrate ports. As part of 802.3bz implementation, the CLI information has been

updated with the latest BASE-T modes.

Use the show interface port-utilization command to view a real-time rate display for all ports on the

switch. The example below shows a sample output from this command.

A show interface port-utilization command listing

switch(config)# show interfaces port-utilization

Status and Counters - Port Utilization

----- -------- + ---------- --------- ----- + ---------- --------- -----

Chapter 3 Port Status and Configuration

| -------------------------- | --------------------------

include vlan1