Vsf Enable; Vsf Disable; Vsf Member Link - HP Aruba JL253A Management And Configuration Manual

For arubaos-switch 16.08

Table of Contents

vsf enable

vsf enable domain <DOMAIN-ID>

Enable VSF on the switch. Allows for switches to be stacked using Ethernet ports.

The domain ID can be from 1 to 4294967295.

NOTE: The command vsf enable causes the switch to reboot once and form the fabric. Upon

reboot, the switch comes up in the "VSF enabled" mode. Port numbers are prefixed with member

numbers, such as "1/1". The configuration on the switch becoming Commander will be retained, but

any pre-existing configuration on other switches will be over-written. The switch will inherit the same

switch software as the member becoming Commander. If the software image of a switch needs to be

updated, the switch will reboot twice.

Disable VSF on the virtual chassis.

This command will not be available until VSF is enabled.

[no] vsf member <MEMBER-ID> link <LINK-ID> [[ethernet] <PORT-LIST> | name <LINK-

NAME> [start-disabled]]

Create the VSF links. A set of physical ports between any two members, carrying VSF traffic, is collectively

referred to as a VSF link.

The VSF member-ID for the member command or parameter. Member ID value can be in the range from 1 to

VSF link ID value 1 to 2.

The port number or a list of ports. Up to eight ports can be assigned into a VSF link.

The VSF link name. Up to 11 characters are allowed for link name.

Operating Notes

Aruba 2930F / 2930M Management and Configuration Guide

for ArubaOS-Switch 16.08