HP Aruba JL253A Management And Configuration Manual page 518

acl
all
cdp
destination
event
ip [fib | forwarding |
packet | rip]
ip [fib [events]]
ip [packet]
518
When a match occurs on an ACL "deny" ACE (with log configured), the
switch sends an ACL message to configured debug destinations. For
information on ACLs, see the "Access Control Lists (ACLs)" in the latest
version of the following guides:
• IPv4 ACLs: access security guide
• IPv6 ACLs: IPv6 configuration guide
NOTE: ACE matches (hits) for permit and deny entries can be
tracked using the show statistics <aclv4|aclv6>
command.
(Default: Disabled—ACL messages for traffic that matches "deny" entries
are not sent.)
Configures the switch to send all debug message types to configured debug
destinations.(Default: Disabled—No debug messages are sent.)
Sends CDP information to configured debug destinations.
logging—Disables or re-enables syslog logging on one or more syslog
servers configured with the logging <syslog-ip-addr>
command.session—Assigns or re-assigns destination status to the
terminal device that was most recently used to request debug
output.buffer—Enables syslog logging to send the debug message types
specified by the debug <debug-type> command to a buffer in switch
memory.For more information on these options, see Debug destinations on
page 519.
Configures the switch to send Event Log messages to configured debug
destinations.
NOTE: This value does not affect the reception of event
notification messages in the Event Log on the switch.
Event Log messages are automatically enabled to be sent to debug
destinations in these conditions:
• If no syslog server address is configured and you enter the logging
<syslog-ip-addr> command to configure a destination address.
• If at least one syslog server address is configured in the startup
configuration, and the switch is rebooted or reset.
Event log messages are the default type of debug message sent to
configured debug destinations.
Sends IP messages to configured destinations.
For the configured debug destinations:events—Sends IP forwarding
information base events.
Enables the specified PIM message type.
Aruba 2930F / 2930M Management and Configuration Guide
Table Continued
for ArubaOS-Switch 16.08