Led Blink Feature; Aruba Central Configuration Manually; Activating Arubaos-Switch Firmware Integration - HP Aruba JL253A Management And Configuration Manual

• TR-69
• Menu
There is a restriction on executing the following commands over CLI:
• boot
• recopy
• erase
• reload
• startup-default
• upgrade-software
• setup
• delete
• reboot
• restore
• menu
• write memory
• amp-server

LED Blink feature

Central connectivity loss is indicated by LEDs. If connectivity is broken and Aruba-Central is enabled, the
USR/FDX and Locator LEDs will blink. The LEDs will stop blinking once the switch is connected back to Central.

Aruba Central Configuration manually

In factory default switches, ZTP with Central is turned ON. ZTP can be disabled in the following scenarios:
• Switches with edited configuration
• Switches where the administrator has explicitly turned off ZTP with Central
In any of the mentioned scenarios, an administrator can manually configure Aruba Central using the aruba-
central command.

Activating ArubaOS-Switch Firmware Integration

CLIs are available for Activate firmware updates which enables, update, checks and shows firmware upgrades.
Chapter 10 Zero Touch Provisioning with AirWave and Central 325