Dhcpv6 Event Messages - HP Aruba JL253A Management And Configuration Manual

For arubaos-switch 16.08
Table of Contents

Advertisement

DHCPv6 event messages

Cause
Events
When the BST becomes full, to indicate that lease
bindings are being dropped.
When DHCPv6 packet validation fails (packets are
received on which they are not expected to).
When a Dynamic binding is replaced with a static
binding on a particular port.
While an attempt to release an Ipv6 address from port
which is leased to another port.
Decline from client to server when client finds the
address issued by server is already in use in the link
where the client is connected.
Decline from client when server assigns an illegal Ipv6
address.
When TFTP transfer of binding state table is a success
or failure.
When a DIPLDv6 enabled port is removed from a
DsnoopV6 enabled vlan.
When DsnoopV6 is disabled globally which makes
DIPLDv6 no longer configured?
When DsnoopV6 is disabled on a particular VLAN
which makes DIPLDv6 also disabled
When a port moved from SAVI-Trust to validating port.
While adding a port to a trunk for which DIPLDv6 is
already enabled.
While enabling DIPLDv6 on a port which is added to a
trunk.
While enabling DIPLDv6 on a port for which ACL is
configured.
When it is unable to add a lock on a particular VLAN
for a particular port due to vlan deny rule.
Chapter 9 DHCPv6 server
Debug messages
Unable to add binding for %x, %02x%02x%02x-%02x
%02x%02x on port %s. BST is full.
Dropping packet as validation failed, reason %s
The dynamic binding for %s on port %s was replaced
with a manual binding.
Unable to release. %02x%02x%02x-%02x%02x%02x
is bound not bound to port %u.
%s: Decline offer from %x (server)of %x because the
address is already assigned to another client.
%s: Decline offer from %x (server) of %x because the
address is illegal.
TFTP of BST from the dsnoopv6 device is successful /
failed.
Port %u is removed from a dhcpv6-snooped VLAN
Dhcpv6-snooping disabled globally, dynamic Ipv6
lockdown also disabled.
Dhcpv6-snooping disabled on VLAN %s, dynamic Ipv6
lockdown also disabled.
Port %u is validating.
Unable to add port %u to trunk, dynamic ipv6 lockdown
is enabled on it.
Unable to configure dynamic Ipv6 lockdown on port %u
which is a part of a trunk.
Unable to configure dynamic Ipv6 lockdown on port
%u, ACL is configured on port.
Access was denied on VLAN %d, deny rule exists on
the VLAN
Table Continued
291

Advertisement

Table of Contents
loading

Table of Contents