Error Log; Invalid Port Error Messages - HP Aruba JL253A Management And Configuration Manual

Description
Shows the uplink failure detection information.
Command context
manager
Examples
switch# show uplink-failure-detection
Uplink Failure Detection Information
UFD Enabled
Track | Monitored
ID | Links
------+----------
1 | Dyn1
32 | Trk1
50 | Trk2
64 | 2/12
If there is a failure, and one track is in Down/Auto-Disabled state, the show uplink-failure-detection
command displays:
switch(config)# show uplink-failure-detection
Uplink Failure Detection Information
UFD Enabled
Track | Monitored
ID | Links
----- + ------------ ------------ ------ ------------- -------- -------- -----
1 | Trk1
2 | A5

Error log

Cause
UFD will log messages in the following scenarios:
• Admin status change.
• When an UFD LtD delay expires, as a result the LtD link is brought up.
• When the UFD Link transition delay is triggered, an LtM returns to service, and as a result the UFD delay is
triggered.

Invalid port error messages

Cause
• When a user specifies an invalid LtM port, a message similar to the following is displayed.
Chapter 3 Port Status and Configuration
: Yes
Links to
Disable
----------- -------- -------
Dyn2
Trk3
Trk4
2/14
: Yes
Links to
Disable
A4
A6
LtM LtD
State State
Up Up
Up Up
Up Up
Up Up
LtM LtD
State State
Up Up
Down Auto-Disabled
LtM LtD
Lacp Key Lacp Key
--------- ---------- ------
1 2
LtM LtD
Lacp Key Lacp Key (sec)
Delay
(sec)
0
300
120
150
Delay
100
0
103