Operating Note; Viewing The Global Poe Power Status Of The Switch - HP Aruba JL253A Management And Configuration Manual

For arubaos-switch 16.08
Table of Contents

Advertisement

System Descr : Switch 3500-24, revision W.14.xx
PortDescr
Pvid
System Capabilities Supported
System Capabilities Enabled
Remote Management Address
Type
Address : 10.0.102.198
Poe Plus Information Detail
Poe Device Type
Power Source
Power Priority
PD Requested Power Value
PSE Actual Power Value

Operating note

The advertisement of power with TLVs for LLDP PoE+ is enabled by default. If LLDP is disabled at runtime and a
PD is using PoE+ power that has been negotiated through LLDP, there will be a temporary power drop. The port
will begin using PoE+ power through the PLC. This event is recorded in the event log. An Example: message
would look like the following:
W 08/04/13 13:35:50 02768 ports: Port A1 PoE power dropped.
Exceeded physical classification for a PoE Type1 device
(LLDP process disabled)
When LLDP is enabled again, it causes a temporary power drop. This event is also recorded in the event log. An
Example: message looks like the following:
W 08/04/13 13:36:31 02771 ports: Port A1 PoE power dropped.
Exceeded physical classification due to change in
classification type (LLDP process enabled)

Viewing the global PoE power status of the switch

Syntax:
show power-over-ethernet [brief | [[ethernet] <port-list>] | [slot <slot-id-range> | all>]]
Displays the switch's global PoE power status, including:
Total Available Power
Lists the maximum PoE wattage available to provision active PoE ports on the switch. This is the amount of
usable power for PDs.
Total Failover Power
Lists the amount of PoE power available in the event of a single power supply failure. This is the amount of
power the switch can maintain without dropping any PDs.
Total Redundancy Power
Indicates the amount of PoE power held in reserve for redundancy in case of a power supply failure.
Total Remaining Power
The amount of PoE power still available.
118
: 23
: 55
: ipv4
: bridge, router
: bridge
: Type2 PD
: Only PSE
: low
: 20 Watts
: 20 Watts
Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08

Advertisement

Table of Contents
loading

Table of Contents