Downloading Switch Software Using Usb; Prerequisites; Copying Using Usb; Copy Flash Usb - HP Aruba JL253A Management And Configuration Manual

For arubaos-switch 16.08
Table of Contents

Advertisement

Example
Display USB port status.
switch# show usb-port
USB port status: enabled
USB port power status: power on

Downloading switch software using USB

Prerequisites

Procedure
1. Store a software version for the switch on a USB flash drive. (The latest software file is typically available from
the Switch Networking website at http://www.hpe.com/networking/support.)
2. Insert the USB device into the switch's USB port.
3. Determine the name of the software file stored on the USB flash drive (for example, K.0800.swi).
4. Decide whether the image will be installed in the primary or secondary flash.

Copying using USB

To copy the primary image to a USB flash drive:
Procedure
1. Insert a USB device into the switch's USB port.
2. Execute the command: switch# copy flash usb K.0800.swi primary/secondary where K.
0800.swi is the name given to the primary flash image that is copied from the switch to the USB device.

copy flash usb

Syntax
copy flash usb <FILENAME>
Description
Uses the USB port to copy the specified flash image from the switch to a USB flash memory device. The default
setting will use the primary image.
Copy a switch software file named K.0800.swi from a USB device to primary flash.
370
(USB device detected in port)
Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08

Advertisement

Table of Contents
loading

Table of Contents