Show Uplink-Failure-Detection - HP Aruba JL253A Management And Configuration Manual

Command context
config
Parameters
<track_ID>
Specifies the track id.
<Port-List>
Specifies the port list.
<delay_value>
Specifies the delay value.
Examples
Configure port A8 as LtM, port A6 as LtD, and delay value as 100 for track 1:
Switch(config)# uplink-failure-detection track 1 links-to-monitor A8
links-to-disable A6 delay 100
switch(config)# show running-config
Running configuration:
; J9851A Configuration Editor; Created on release #KB.16.08.0001
; Ver #14:01.4f.f8.1d.fb.7f.bf.bb.ff.7c.59.fc.7b.ff.ff.fc.ff.ff.3f.ef:4e
hostname "switch"
module A type j9993a
module L type j9992a
snmp-server community "public" unrestricted
oobm
ip address dhcp-bootp
exit
uplink-failure-detection
uplink-failure-detection track 1 links-to-monitor A8 links-to-disable A6 delay 100
vlan 1
name "DEFAULT_VLAN"
untagged A1-A8,L1-L21
ip address dhcp-bootp
ipv6 enable
ipv6 address dhcp full
exit
To set delay value to 2:
switch(config)# uplink-failure-detection track 1 delay 2
To set delay value to 0:
switch(config)#no uplink-failure-detection track 1 delay 2
Alternately, to set delay value to 0, a user can also use the following command:
switch(config)#uplink-failure-detection track 1 delay 0

show uplink-failure-detection

Syntax
show uplink-failure-detection
102 Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08