Viewing Sflow Configuration And Status (Cli) - HP Aruba JL253A Management And Configuration Manual

Once an sFlow receiver/destination has been enabled, this command enables flow sampling for that instance.
The receiver-instance number is 1, 2, or 3, and the sampling rate is the allowable non-zero skipcount for the
specified port or ports.
To disable flow-sampling for the specified port-list, repeat the above command with a sampling rate of 0.
Syntax:
sflow <receiver-instance> polling <port-list> <polling interval>
Once an sFlow receiver/destination has been enabled, this command enables counter polling for that instance.
The receiver-instance number is 1, 2, or 3, and the polling interval may be set to an allowable non-zero value to
enable polling on the specified port or ports.
To disable counter-polling for the specified port-list, repeat the above command with a polling interval of 0.
NOTE:
Under the multiple instance implementation, sFlow can be configured via the CLI or via SNMP.
However, CLI-owned sFlow configurations cannot be modified via SNMP, whereas SNMP-owned
instances can be disabled via the CLI using the no sflow <receiver-instance> command.

Viewing sFlow Configuration and Status (CLI)

The following sFlow commands allow you to display sFlow configuration and status through the CLI Viewing
sFlow destination information on page 214 is an example of sflow agent information.
Syntax:
show sflow agent
Displays sFlow agent information. The agent address is normally the IP address of the first VLAN configured.
The show sflow agent command displays read-only switch agent information. The version information shows
the sFlow version, MIB support, and software versions; the agent address is typically the IP address of the first
VLAN configured on the switch.
Viewing sflow agent information
switch# show sflow agent
Version
Agent Address
Syntax:
show sflow <receiver instance> destination
Displays information about the management station to which the sFlow sampling-polling data is sent.
The show sflow instance destination command includes information about the management-station's
destination address, receiver port, and owner, as shown in the following example.
Viewing sFlow destination information
switch# show sflow 2 destination
Destination Instance
sflow
214
1.3;XX.11.40
10.0.10.228
2
Enabled
Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08