HP Aruba JL253A Management And Configuration Manual page 32

Selects TimeP as the time synchronization method.
Syntax:
ip timep dhcp
Configures DHCP as the TimeP mode.
For example, suppose:
• Time Synchronization is configured for SNTP.
• You want to:
◦ View the current time synchronization.
◦ Select TimeP as the synchronization mode.
◦ Enable TimeP for DHCP mode.
◦ View the TimeP configuration.
Enabling TimeP in Manual Mode
Like DHCP mode, configuring TimeP for Manual Mode enables TimeP. However, for manual operation, you must
also specify the IP address of the TimeP server. (The switch allows only one TimeP server.) To enable the TimeP
protocol:
Syntax:
timesync timep
Selects TimeP.
Syntax:
ip timep manual <ip-addr>
Activates TimeP in manual mode with a specified TimeP server.
Syntax:
[no] ip timep
Disables TimeP.
NOTE:
To change from one TimeP server to another, you must use the no ip timep command to disable
TimeP mode, the reconfigure TimeP in manual mode with the new server IP address.
Example:
To select TimeP and configure it for manual operation using a TimeP server address of 10.28.227.141 and the
default poll interval (720 minutes, assuming the TimeP poll interval is already set to the default):
switch(config)# timesync time
Selects TimeP.
switch(config)# ip timep manual 10.28.227.141
Activates TimeP in Manual mode.
32 Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08