Table of Contents
Advertisement
no ip address
exit
Configuration restore without reboot
The cfg-restore without reboot command restores the configuration without reboot from a backup
configuration to the running configuration of the switch.
The details about the difference between a running and a backup configuration can be displayed using cfg-
restore {flash | tftp | sftp} <FILE-NAME> diff command.
More information
Configuration backup on page 557
Viewing the differences between a running configuration and a backup configuration on page 572
cfg-restore
Syntax
cfg-restore {flash | tftp <IP-ADDRESS> | sftp <IP-ADDRESS>} <FILE-NAME> [diff |
force | non-blocking | recovery-mode | verbose]
Description
Restores the given configuration as the running configuration without reboot. If the configuration is not suitable to
successfully restore without reboot, the command will return a failure message with details.
NOTE: The restored configuration commands will be executed on a running configuration, so the
name of the current active configuration does not change after configuration restore, except for the
force option.
Command context
config
Parameters
flash
Copies file from flash.
tftp
Copies file from TFTP server.
sftp
Copies file from SFTP server.
<IP-ADDRESS>
IP address of the TFTP server.
<FILE-NAME>
Name of the backup configuration file to restore into the running configuration.
diff
Provides the list of changes that will be applied on the running configuration.
560
Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08
Advertisement
Table of Contents
Troubleshooting
