Table of Contents
Advertisement
Information
Debug
Using the logging severity command, you can select a set of Event Log messages according to their
severity level and send them to a syslog server. Messages of the selected and higher severity will be sent. To
configure a syslog server, see Configuring a syslog server on page 521.
Syntax:
[no] logging severity {< major | error | warning | info | debug >}
Configures the switch to send all Event Log messages with a severity level equal to or higher than the specified
value to all configured Syslog servers.
Default: debug (Reports messages of all severity levels.)
Use the no form of the command to remove the configured severity level and reconfigure the default value, which
sends Event Log messages of all severity levels to syslog servers.
NOTE: The severity setting does not affect event notification messages that the switch normally
sends to the Event Log. All messages remain recorded in the Event Log.
Configuring the system module used to select the Event Log messages sent to a syslog
server
Event Log messages contain the name of the system module that reported the event. Using the logging
system-module command, you can select a set of Event Log messages according to the originating system
module and send them to a syslog server.
Syntax:
[no] logging system-module <system-module>
Configures the switch to send all Event Log messages being logged from the specified system module to
configured syslog servers. (To configure a syslog server, see Configuring a syslog server.)
See Event Log system modules for the correct value to enter for each system module.
Default: all-pass (Reports all Event Log messages.)
Use the no form of the command to remove the configured system module value and reconfigure the default
value, which sends Event Log messages from all system modules to syslog servers.
You can select messages from only one system module to be sent to a syslog server; you cannot configure
messages from multiple system modules to be sent. If you re-enter the command with a different system module
name, the currently configured value is replaced with the new one.
NOTE: This setting has no effect on event notification messages that the switch normally sends to
the Event Log.
Enabling local command logging
Use this command to enable local command logging. This satisfies the NDcPP certification requirement that:
•
All administrative actions (commands) are logged locally.
•
Local command log storage can be enabled and disabled.
Chapter 13 Troubleshooting
Information on a normal switch event.
Reserved for switch internal diagnostic information.
525
Advertisement
Table of Contents
Troubleshooting
