Component Testing
Groundsmaster
®
5900 & 5910
16227SL Rev B
For accurate resistance and/or continuity checks, electrically disconnect the
component being tested from the circuit (e.g. unplug the wire harness connector
from the key switch before doing a continuity check of the switch).
Note: For engine component testing information, see the Yanmar Model
4TNV98CT−NTRL
Yanmar Service Manual
When testing electrical components for continuity with a multimeter
(ohms setting), make sure that power to the circuit has been
disconnected.
or
Yanmar Troubleshooting
CAUTION
Page 6–53
Manual.
Electrical System: Component Testing