Drive Belt Idler Assembly Installation
Groundsmaster
®
5900 & 5910
16227SL Rev B
(Figure
4. Use a ⅜" or ½" drive ratchet or breaker bar to relieve idler pulley tension
and install drive belt. Make sure that idler pulley applies tension against the
back side of the belt.
g299399
1.
High idler arm
2.
Stop bolt
5. On front deck, make sure that clearance between lower belt (center) idler
arm and stop bolt head is 2.5 to 4.0 mm (0.10 to 0.16 in)
as necessary.
6. Install all deck covers to cutting deck.
328) (continued)
Figure 330
3.
Jam nut
Page 8–13
(Figure
330). Adjust
Cutting Decks: Service and Repairs