Toro Groundsmaster 5900 Series Service Manual page 233

Steering Control Valve Installation
Groundsmaster ® 5900 & 5910
16227SL Rev B
(Figure
3. Hold steering column in position on machine and slide steering control valve
onto lower end of steering column. Secure steering column and steering
control valve to machine with four (4) cap screws. Tighten cap screws from
47 to 56 N·m (34 to 42 ft−lb).
4. Remove hydraulic caps or plugs installed during removal to prevent
contamination.
5. Connect hydraulic tubes to fittings on steering valve using tags placed during
control valve removal to identify correct tube placement (see
Hydraulic Hoses and Tubes (O-Ring Face Seal) (page
6. If traction pedal was removed to access hydraulic hoses, reinstall traction
pedal to Operator platform and adjust traction pedal for neutral (see
Pedal Neutral Adjustment (page
7. Lower the steering column boot and install the steering cover (see
Column (For machines serial number below 403450000) (page
8. Fill reservoir with correct hydraulic fluid as required.
9. Check hydraulic system for leaks before returning the machine to service.
116) (continued)
6–49)).
Page 5–133
Installing
5–7)).
Traction
Steering
7–5)).
Hydraulic System: Service and Repairs