Toro Groundsmaster 5900 Series Service Manual page 97

Engine Removal (continued)
Engine Installation
Groundsmaster ® 5900 & 5910
16227SL Rev B
Make sure to not damage the engine, fuel lines, hydraulic lines,
electrical harness or other machine components while removing
the engine.
17. Carefully raise engine from the machine.
18. If necessary, remove engine mount brackets from the engine.
19. If necessary, remove engine isolator mounts from frame. Note ground
connection at right rear isolator mount.
20. Cover or plug all engine openings to prevent contaminants from entering
engine.
1. If removed, install engine isolator mounts to frame.
2. If removed, install engine mount brackets to engine and tighten cap screws
from 54 to 65 N·m (40 to 48 ft−lb).
3. Make sure that all parts removed from the engine during maintenance or
rebuilding are correctly installed to the engine.
4. Remove all covers and plugs from engine openings that were placed during
engine removal.
Make sure that hoist or lift used to install engine can properly
support engine. Engine weighs approximately 295 kg (650 lb).
5. Connect suitable hoist or lift to the front and rear lift tabs on engine. Do not
allow the lift chains or straps to contact the DPF.
One person should operate lift or hoist while the other person guides
the engine into the machine.
Make sure not to damage the engine, fuel and hydraulic lines,
electrical harness or other parts while installing the engine.
6. Slowly lower engine into the machine.
7. Install the piston (traction) pump (see
8. Align engine mount brackets to the engine isolator mounts and secure with
cap screws, snubbing washers and lock nuts
9. On Groundsmaster 5910 machines, install air conditioning compressor (see
Air Conditioning Compressor (page
IMPORTANT
CAUTION
CAUTION
IMPORTANT
Piston (Traction) Pump (page
9–6)).
Page 4–29 Yanmar Diesel Engine: Service and Repairs
5–94)).
(Figure 27).