Component Testing
Reelmaster
®
3100-D/3105-D
20252SL Rev A
For accurate resistance and/or continuity checks, electrically disconnect the
component being tested from the circuit (e.g. unplug the key switch connector
before doing a continuity check).
Note: For engine component testing information (starter solenoid and motor,
alternator, glow plugs) see the
When testing electrical components for continuity with a multimeter
(ohms setting), make sure that power to the circuit has been
disconnected.
Kubota Workshop
CAUTION
Page 6–9
Manual.
Electrical System: Component Testing