Toro Groundsmaster 5900 Series Service Manual page 423

Removal (Figure 292) (continued)
Installation (Figure
Groundsmaster ® 5900 & 5910
16227SL Rev B
4. Use a suitable puller to remove the steering tower to get access to the
fasteners that secure the steering tower to the machine.
5. Slide the rubber bellows up the steering tower to get access to the fasteners
that secure the steering tower to the machine.
6. Support the steering control valve to prevent it from falling during the steering
tower removal.
Note: Do not allow the steering control valve to hang from the hydraulic lines.
7. Remove the steering tower as needed using the
g278374
1. Steering tower
2. Pin
3. Lock washer (2 each)
4. Release pin
5. Cylinder shaft
6. Jam nut
7. Cylinder
8. Disassemble the steering tower assembly as necessary; refer to
292)
1. Assemble the steering tower; refer to
2. After assembly, ensure that the release pin on the end of the cylinder shaft is
positioned against the pedal. The jam nut on the cylinder shaft can be used
to adjust the location of the release pin.
3. Install the steering tower using the
4. Secure the steering wheel to the steering column assembly with the flat
washer and locknut.
5. Install the steering wheel cover onto the steering wheel.
Figure 293
8. Bolt (2 each)
9. Pin
10. Pedal block
11. Pedal
12. Spring
13. Universal joint
14. Pin
Figure
Figure 292
Page 7–9
Figure 292 as a guide.
Figure
293.
as a guide.
Chassis: Service and Repairs
293.