Engine - Toro Groundsmaster 5900 Series Service Manual

Engine

3
4
2
g287541
1. Cooler frame assembly
2. Battery−disconnect switch bracket
Engine Removal
Groundsmaster ® 5900 & 5910
16227SL Rev B
4
5
3. Flange not (3)
4. Carriage screw (4)
1. Park machine on a level surface, lower cutting decks, stop engine and
remove key from the key switch.
The engine, exhaust pipe, radiator and oil cooler may be hot. To
avoid possible burns, allow the machine to cool before working on
or near these components.
2. Turn the battery−disconnect switch to the OFF position and disconnect the
battery positive (+) cables at the batteries of the 12 Volt and 24 Volt systems.
3. If engine is to be disassembled, drain oil from engine.
4. Remove hood (see
5. Drain radiator into a suitable container using the radiator drain. The radiator
drain is located inside the right frame rail near the rear wheel.
6. Loosen hose clamps and disconnect upper and lower coolant hoses from
the radiator.
7. Loosen hose clamp and disconnect the air intake hose from the engine.
Figure 24
CAUTION
Hood Removal (Figure 321) (page
Page 4–25
1
6
5
6
5. Flange nut (6)
6. Cap screw (6)
7–48)).
Yanmar Diesel Engine: Service and Repairs
6