Console Arm Disassembly
Console Arm Assembly
Chassis: Service and Repairs
(Figure
313)
1. Park machine on a level surface, lower cutting units, and stop engine.
Remove key from key switch.
2. Remove six (6) flange head screws and side cover (item 2) from outside
of console arm.
3. Remove four (4) flange head screws that secure front cover (item 4) to
console arm panel.
4. Loosen two (2) flange head screws (item 7) to open console gate (item 6).
5. Remove electrical components from console arm as needed.
6. If necessary, remove console arm and supports from machine.
(Figure
313)
1. If removed, install console arm and supports to machine. Tighten cap screw
(item 9) securing console support and seat belt receptacle to seat from 68
to 81 N·m (50 to 60 ft−lb).
2. Install all removed electrical and console arm components.
3. Close console gate and tighten two (2) flange head screws (item 7).
4. Secure front cover (item 4) to console arm with four (4) flange head screws.
5. Secure side cover to console arm (item 2) with six (6) flange head screws.
Page 7–36
Groundsmaster
®
5900 & 5910
16227SL Rev B