Toro Groundsmaster 5900 Series Service Manual page 472

Wing Cutting Deck Removal
Wing Cutting Deck Installation
Cutting Decks: Service and Repairs
See Drive Belt Idler Assemblies (page
Castor Forks and Wheels (page 8–21)
(Figure 339 and Figure 340) (page 8–23)
information.
(Figure 327)
1. Position machine on a clean, level surface. Lower cutting decks, stop engine
and remove key from the key switch.
2. Remove cutting deck outer cover to access hydraulic deck motor.
3. Remove three (3) hose guides from cutting deck. Leave two (2) loop guides
(item 6 and 7) on hydraulic hoses.
4. Remove hydraulic motor from cutting deck (see
5–118)). Position and support motor away from cutting deck. DO NOT allow
cutting deck motor to hang from hydraulic hoses.
5. Remove eight (8) flange head screws (item 11) and lock nuts that secure
deck connection (item 10) to cutting deck.
6. Start engine and raise lift arm slightly. Stop engine and remove key from the
key switch.
7. Slide the cutting deck away from the traction unit.
(Figure 327)
1. Position machine on a clean, level surface. Lower wing deck lift arm, stop
engine and remove key from the key switch.
2. Position the wing cutting deck to a partially raised lift arm.
3. Start engine and lower lift arm while aligning deck connection to cutting deck.
Stop engine and remove key from the key switch.
4. Install deck connection to cutting deck with eight (8) flange head screws (item
11) and lock nuts and tighten fasteners.
5. Install hydraulic motor to cutting deck (see
6. Position and secure three (3) hose guides to cutting deck.
7. Install all removed cutting deck covers.
8. Lubricate grease fittings on cutting deck and lift arm assemblies (see
machine Operator's Manual).
8–11), Blade Spindles (page
and Deck Skids and Front Deck Roller
for removal, installation and service
Cutting Deck Motor (page
Page 8–10
8–14),
Cutting Deck Motor (page
5–118)).
Groundsmaster ® 5900 & 5910
16227SL Rev B