Toro Groundsmaster 5900 Series Service Manual page 486

Deck Skids and Front Deck Roller Installation (continued)
Cutting Decks: Service and Repairs
g299740
1. Skid/Bumper
2. Flange nut (2)
3. Carriage bolt (2)
4. Flange head screw
1. Install skids and rollers to deck.
A. Make sure to install all the skid/bumpers on all the cutting decks in the
same mounting hole height position (lower, middle or upper).
B. The flange head screw at the front of each deck skid/bumper threads
into the skid/bumper. Tighten the flange head screws (item 4) from 9 to
11 N·m (80 to 100 in−lb).
C. Make sure to install the inner skids on the wing decks in the same
mounting hole height position (lower, or upper).
D. Install front deck roller in correct mounting hole based on desired
height−of−cut.
Figure 340
5. Inner skid
6. Carriage bolt (3)
7. Lock nut (3)
Page 8–24 Groundsmaster ® 5900 & 5910
16227SL Rev B