Toro Groundsmaster 5900 Series Service Manual page 477

Blade Spindle Removal (continued)
Groundsmaster ® 5900 & 5910
16227SL Rev B
5. Start the engine and raise the cutting deck. Stop engine and remove key
from the key switch. Latch or block up the cutting deck so it cannot lower
accidentally.
g299690
1. Flange screw
2. Hydraulic motor
3. Drive spindle
4. Blade bolt
5. Anti−scalp cup
6. Remove cutting blade, anti−scalp cup and blade bolt from spindle to be
serviced (Figure 332).
7. Remove spindle housing assembly from deck.
A. For driven spindle assemblies, remove eight (8) flange nuts that secure
spindle to deck.
B. For drive spindle assemblies, record spindle orientation and loosen and
remove four (4) flange nuts that secure spindle to deck. Then, remove
four (4) cap screws and flat washers that secure spindle and hydraulic
motor mount to deck.
Figure 332
6. Blade
7. Carriage bolt
8. Flange nut
9. Cap screw
10. Flat washer
Page 8–15 Cutting Decks: Service and Repairs